ORBIT HYDRAULIC SYSTEM

GEROTOR HYDRAULIC MOTOR INDIA

ORBIT Make Hydraulic Motors OHM OHP OHR OHH OHS OHT OHV Manufacturers & Suppliers India

Hawe Pressure Control Valves

Pressure reducing valves
Pressure reducing valves are a type of pressure control valve. They maintain a largely constant outlet pressure even at a higher and changing inlet pressure.


Directional valves

Shut-off valves or accumulator charging valves are a type of pressure control valve. They switch the delivery flow of a pump to unpressurised circulation if the pressure value set is reached. During this process the consumer side is separated from the idle circulation by a zero-leakage check valve. If the pressure drops in the consumer side, the idle circulation is interrupted and the oil fed to the consumer again.


Load-holding valves

Load-holding valves are a type of pressure control valve. They prevent loads on cylinders or motors dropping in an uncontrolled manner. For this purpose they are pre-loaded with a pressure setting that is higher than the largest possible load. A hydraulic piston controls the opening of the valve to achieve the required lowering velocity.


Pressure-limiting valves, pre-load valves

Pressure-limiting valves are a type of pressure control valve. They safeguard the system against excessive system pressure or limit the operation pressure.

Pre-load valves, also called sequence valves are a type of pressure control valve. They generate a largely constant pressure gradient between the inlet and outlet on the valve. In the opposite direction the flow can pass freely. In the normal position the valve has minor leakage.

Hawe Pressure Control Valves

Pressure control valves influence the system pressure in a specific, pre-determined manner. This is achieved by altering the throttling cross-sections with the aid of mechanical, electrical or hydraulic movements.

The range includes pressure-limiting valves, pressure-reducing valves, switching valves and load-holding valves.

Hawe Pressure Control Valves